Bilt Hamber Touch-Less v2 Pre-Wash - 5L

Bilt Hamber Laboratories premium car care products from THE UK

• TOUCH-LESS is our new eco-friendly pressure-washer, pre-clean, snow foam which can be applied by pump spray, foam cannon or foam gun.
• Applied at typically a 4% PIR this bio-degradable sugar-based product provides truly exceptional levels of cleaning of automotive paintwork.
• Unlike other petrochemical-based cleaners, TOUCH-LESS is free-and-easy rinsing, easing the effort of subsequent bucket washes and massively helping post-treatments bond.
• TOUCH-LESS also contains corrosion inhibitors. Packed in 5 litre PH:10-11, contains no phosphates, solvents, NTA, or caustic soda.

How To Use
TOUCH-LESS may be applied with trigger spray, pump spray, pressure washer, or snow foam lance. The minimum recommended dilution rate should be 2% PIR (Panel Impact Ratio) and up to 5% for very dirty vehicles. 

Step 1

Fill the detergent bottle or reservoir (on machine or lance) up to capacity with plain water. Turn detergent feed to full. Take a large bucket or container and discharge the lance into this, watching the detergent bottle until empty. Once empty, stop.

Step 2

The following calculations will achieve 4% dilution; Measure the total amount collected and multiply this number by 0.04 (Total can be measured in either volume with a measuring jug or by weight) this is the amount of TOUCH-LESS to use.

We recommend 50ml Touchless to 950ml of water in your foam cannon

Step 3

Add the calculated amount from STEP TWO to the pressure-washer reservoir and top up to full with cold water and shake in for a few moments.

Step 4

Apply touchless to the entire vehicle or panel by panel. Allow soaking for 1-5 minutes (but never allow to dry). Power-wash off.

It is not necessary to use all diluted touch-less in one wash. One litre of diluted product should last 4-5 washes.

Apply to cool panels in shaded conditions. Do not allow this product to dry in use. Keep the bottleneck and lid clean.

Safety Data Sheet